ASTM-D2967 2017
$29.79
D2967-07(2017) Standard Test Method for Corner Coverage of Powder Coatings
| Published By | Publication Date | Number of Pages |
| ASTM | 2017 | 3 |
ASTM D2967-07-Reapproved2017
Active Standard: Standard Test Method for Corner Coverage of Powder Coatings
ASTM D2967
Scope
1.1 This test method covers the determination of the ratio of corner thickness (see 3.1.3) to face thickness (see 3.1.4) of powder coatings applied to a specific face thickness by dipping preheated square bars into aerated powder and curing the coating using predetermined conditions.
Note 1: The property of corner coverage has also been referred to as “edge coverage,” though the latter is not recommended. There are widespread misunderstandings and expectations relative to the term “edge coverage.” This test is performed on a steel bar having square corners and the results do not necessarily relate to edges that are sharper, that is, burrs. A coating that has measurable corner coverage may still not protect sharper edges from corrosion or provide the electrical insulation needed in some applications.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
coating powder; corner coverage; corner thickness; edge coverage; face thickness; powder coating;
ICS Code
ICS Number Code 29.035.99 (Other insulating materials)
DOI: 10.1520/D2967-07R17
