ASTM-D3222 2010

$40.63

D3222-05(2010) Standard Specification for Unmodified Poly(Vinylidene Fluoride) (PVDF) Molding Extrusion and Coating Materials

Published By	Publication Date	Number of Pages
ASTM	2010	5

Guaranteed Safe Checkout

Categories: 83.080.20 - Thermoplastic materials, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D3222-05-Reapproved2010

Historical Standard: Standard Specification for Unmodified Poly(Vinylidene Fluoride) (PVDF) Molding Extrusion and Coating Materials

ASTM D3222

Scope

1.1 This specification covers melt processable molding and extrusion materials, as well as coating materials of poly(vinylidene fluoride) fluoroplastic, commonly abbreviated PVDF (or PVF₂ in scientific literature). This specification covers thermoplastic resin materials supplied in pellet or powder form.

1.2 This specification applies only to the virgin homopolymer prepared from vinylidene fluoride, not copolymers, reinforced, filled grades or special grades with additives or treatments for modification of attributes.

1.3 The tests involved are intended to provide information for specification of unmodified PVDF homopolymer resins. It is not the purpose of this specification to provide engineering data for design purposes.

1.4 PVDF fluoroplastics melt between 156 and 180°C (312 and 356°F) and are thermally stable up to about 370°C (698°F). (Warning—Evolution of corrosive and toxic hydrogen fluoride can occur under certain conditions.)

1.5 The values stated in SI units, as detailed in , are to be regarded as the standard. The values given in parentheses are for information only.

Note 1—PVDF exhibits polymorphism. The type and extent of crystalline structure varies with the thermomechanical history of the sample. Specimens prepared by techniques different than prescribed in this specification can have properties that vary from the values specified.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 10.

Note 2—There is no equivalent ISO standard for this specification. Information in this specification is technically equivalent to related information in ISO 12086-1 and ISO 12086-2.

Keywords

extrusion materials; fluorohydrocarbon plastics; fluoropolymers; molding materials; polyvinylidene fluoride (PVDF); Poly(vinylidene fluoride)(PVDF)–specifications; Unmodified PVDF molding/extrusionmaterials; Molding/extrusion compounds/materials–specifications; Extrusion compounds (plastic)–specifications; Fluorohydrocarbon plastics; Melt-processible fluoropolymers–specifications

ICS Code

ICS Number Code 83.080.20 (Thermoplastic materials)

DOI: 10.1520/D3222-05R10

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Terminology Classification General Requirements Detail Requirements TABLE 1
3	Sampling Preparation of Compression Molded Specimens
4	Test Conditions Handling Packaging Inspection and Certification Precision and Bias Keywords

Additional information

Standard Title	D3222-05(2010) Standard Specification for Unmodified Poly(Vinylidene Fluoride) (PVDF) Molding Extrusion and Coating Materials
Published Code	ASTM
Publication Date	2010
Pages Count	5
ICS Codes	83.080.20 - Thermoplastic materials