ASTM-D3299 2000
$44.96
D3299-00 Standard Specification for Filament-Wound Glass-Fiber-Reinforced Thermoset Resin Corrosion-Resistant Tanks
| Published By | Publication Date | Number of Pages |
| ASTM | 2000 | 17 |
ASTM D3299-00
Historical Standard: Standard Specification for Filament-Wound Glass-Fiber-Reinforced Thermoset Resin Corrosion-Resistant Tanks
ASTM D3299
Scope
1.1 This specification covers cylindrical tanks fabricated by filament winding for above-ground vertical installation, to contain aggressive chemicals at atmospheric pressure as classified herein, and made of a commercial-grade polyester or vinylester resin. Included are requirements for materials, properties, design, construction, dimensions, tolerances, workmanship, and appearance.
1.2 This specification does not cover the design of vessels intended for pressure above atmospheric, vacuum conditions, except as classified herein, or vessels intended for use with liquids heated above their flash points.
1.3 The values given in parentheses are provided for information purposes only.
Note 1-Special design consideration should be given to vessels subject to superimposed mechanical forces, such as earthquakes, wind load, or agitation, and to vessels subject to service temperature in excess of 180°F (82°C), and to vessels with unsupported bottoms. Note 2-There is no similar or equivalent ISO standard.
1.4 The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
above ground; atmospheric; filament wound; polyester; tank; vinylester
ICS Code
ICS Number Code 23.020.10 (Stationary containers and tanks)
DOI: 10.1520/D3299-07
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology |
| 2 | Classification Materials and Manufacture Design Requirements Design Requirements |
| 3 | FIG. 1 |
| 4 | FIG. 2 |
| 5 | TABLE 1 FIG. 3 |
| 6 | TABLE 2 |
| 7 | TABLE 3 |
| 8 | TABLE 4 FIG. 4 |
| 9 | Laminate Construction Requirements FIG. 5 FIG. 6 |
| 10 | TABLE 5 |
| 12 | Dimensions and Tolerances FIG. 7 TABLE 6 |
| 13 | Workmanship, Finish, and Appearance TABLE 7 FIG. 8 |
| 14 | Requirements Test Methods Product Marking Packaging and Package Marking Shipping Keywords |
| 15 | X1. HANDLING AND INSTALLATION X1.1 Handling X1.2 Installation X2. DISHED BOTTOM X2.1 |
| 16 | X3. EXPRESSION OF HOOP TENSILE MODULUS OF A LAMINATE X3.1 FIG. X2.1 |
