ASTM-D330 2007(Redline)

$23.40

D330-07 Standard Specification for 2-Butoxyethanol (Redline)

Published By	Publication Date	Number of Pages
ASTM	2007

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

Abstract

This specification covers the properties and requirements for 2-butoxyethanol. Specimens shall be suitably sampled and tested, and shall meet specified values of the following properties: apparent specific gravity; color (Pt-Co scale); distillation range (initial boiling point and dry point); water content; and acidity (free acid as acetic acid).

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

1.1 This specification covers 2-butoxyethanol.

1.2 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off ‘to the nearest unit’ in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E 29.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 For specific hazard information and guidance, see the supplier’s Material Safety Data Sheet for materials listed in this specification.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

U.S. Federal Standard

PPP-C-2020 Specification for Packaging of Chemicals, Liquid, Dry, and Paste Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil.

ASTM Standards

D268 Guide for Sampling and Testing Volatile Solvents and Chemical Intermediates for Use in Paint and Related Coatings and Material D1078 Test Method for Distillation Range of Volatile Organic Liquids D1209 Test Method for Color of Clear Liquids (Platinum-Cobalt Scale) D1364 Test Method for Water in Volatile Solvents (Karl Fischer Reagent Titration Method) D1613 Test Method for Acidity in Volatile Solvents and Chemical Intermediates Used in Paint, Varnish, Lacquer, and Related Products D4052 Test Method for Density, Relative Density, and API Gravity of Liquids by Digital Density Meter D5386