Shopping Cart

No products in the cart.

ASTM-D3454 2011

$40.63

D3454-11 Standard Test Method for Radium-226 in Water

Published By Publication Date Number of Pages
ASTM 2011 9
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM D3454-11

Historical Standard: Standard Test Method for Radium-226 in Water

ASTM D3454

Scope

1.1 This test method covers the measurement of soluble, suspended, and total radium-226 in water in concentrations above 3.7 × 103 Bq/L. This test method is not applicable to the measurement of other radium isotopes.

1.2 This test method may be used for quantitative measurements by calibrating with a radium-226 standard, or for relative measurements by comparing the measurements made with each other.

1.3 This test method does not meet the current requirements of Practice D2777.

1.4 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.

1.5 Hydrofluoric acid (HF) is very hazardous and should be used in a well-ventilated hood. Wear rubber gloves, safety glasses or goggles, and a laboratory coat. Avoid breathing any HF fumes. Clean up all spills promptly and wash thoroughly after using HF.

1.6 This standard does not purport to address all of the other safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

coprecipitation; emanation; radioactivity; 226Ra; 222Rn; water: Radioactive water analysis; Radium content–water

ICS Code

ICS Number Code 13.060.50 (Examination of water for chemical substances)

DOI: 10.1520/D3454-11

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
Summary of Test Method
Significance and Use
2 Interferences
Apparatus
Reagents and Materials
TABLE 1
FIG. 1
3 FIG. 2
FIG. 3
4 Sampling
Calibration and Standardization
5 Procedure
6 Calculation
TABLE 2
7 Precision and Bias
Quality Assurance
8 FIG. 4
9 Keywords
References
ASTM-D3454 2011
$40.63