ASTM-D4575 2009

$40.63

D4575-09 Standard Test Methods for Rubber Deterioration—Reference and Alternative Method(s) for Determining Ozone Level in Laboratory Test Chambers

Published By	Publication Date	Number of Pages
ASTM	2009	10

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D4575-09

Historical Standard: Standard Test Methods for Rubber Deterioration—Reference and Alternative Method(s) for Determining Ozone Level in Laboratory Test Chambers

ASTM D4575

Scope

1.1 These test methods cover the following three types of methods for the determination of ozone content in laboratory test chambers. Method A (UV absorption) is specified for reference or referee purposes and as a means of calibration for the alternative methods; Method B, instrumental device (electrochemical or chemiluminescence); and Method C, wet chemical techniques (see Appendix X1). These methods are primarily intended for use with tests for determining rubber ozone cracking resistance and thus are applicable over the ozone level range from 25 to 200 mPa.

Note 1—Prior to 1978, ozone concentrations were expressed in ASTM D11 Standards in parts per hundred million (pphm) of air by volume. See Appendix X2 for an explanation of the change to partial pressure in millipascals (mPa).

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see Note 2 and 5.1.

Note 2—Warning—Ozone is a hazardous chemical.

Keywords

chemical; deterioration; ozone measurement; rubber test; ultraviolet; Absorption methods; Calibration–rubber analysis instrumentation; Chemiluminescence detection; Deterioration–rubber; Electrochemical measurements/testing; Modified spray-jet device; Ozone (O3) cracking; Reference testing methods; Rotameter applications/analysis; Rubber (ozone cracking); Single column absorption; Spray-jet device; Ultraviolet (UV) analysis–rubber; Wet chemical analysis

ICS Code

ICS Number Code 83.060 (Rubber)

DOI: 10.1520/D4575-09

PDF Catalog

PDF Pages	PDF Title
1	Scope
2	Referenced Documents Summary of Methods Significance and Use Hazards Calibration of Nonreference Methods
3	Sampling Preparation of Apparatus TABLE 1
4	Preparation of Apparatus Calibration General Theory Reagents Preparation of Apparatus FIG. 1
5	FIG. 2 FIG. 3 FIG. 4
6	Directions for Ozone Measurement
7	Test Report Precision and Bias Keywords X1. THE EFFECT OF AMBIENT ATMOSPHERIC PRESSURE ON OZONE CRACKING OF RUBBER
8	X1.1 Simple Analysis of Test Results TABLE X1.1
9	X2. BRIEF DESCRIPTION OF A TYPICAL UV OZONE MEASUREMENT DEVICE AND AUTOMATIC OZONE CALIBRATOR X2.1 UV Ozone Measurement Device X2.2 Automatic Ozone Calibrator REFERENCES

Additional information

Standard Title	D4575-09 Standard Test Methods for Rubber Deterioration—Reference and Alternative Method(s) for Determining Ozone Level in Laboratory Test Chambers
Published Code	ASTM
Publication Date	2009
Pages Count	10