ASTM-D4618:2003 Edition

$40.63

D4618-92(2003) Standard Specification for Design and Fabrication of Flue Gas Desulfurization System Components for Protective Lining Application

Published By	Publication Date	Number of Pages
ASTM	2003	5

Guaranteed Safe Checkout

Categories: 13.040.40 - Stationary source emissions, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D4618-92-Reapproved2003

Historical Standard: Standard Specification for Design and Fabrication of Flue Gas Desulfurization System Components for Protective Lining Application

ASTM D4618

Scope

1.1 This specification covers the design and fabrication of metal components for Flue Gas Desulfurization (FGD) equipment, including absorbers, tanks, chimney liners, ductwork and associated equipment that are to be lined for corrosion or abrasion resistance, or both.

1.2 Limitations

1.2.1 This specification is intended only to define the design considerations for successful application and performance of protective linings for FGD system components.

1.2.2 It does not cover structural performance of FGD components.

1.2.3 It does not cover use of metallic linings.

1.3 This specification represents the minimum requirements for lining work. In cases where the manufacturer’s instructions and recommendations differ from this specification, these differences must be resolved before fabrication is started.

1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

absorbers; chemical-resistant; coating; components; design; desulfurization; ductwork; fabrication; FGD system; flue gas; lining; tanks; welds

ICS Code

ICS Number Code 13.040.40 (Stationary source emissions)

DOI: 10.1520/D4618-92R03

PDF Catalog

PDF Pages	PDF Title
1	Scope Design/Engineering Requirements
2	Fabrication TABLE 1 FIG. 1
3	Miscellaneous Keywords FIG. 2
4	FIG. 2 FIG. 2

Additional information

Standard Title	D4618-92(2003) Standard Specification for Design and Fabrication of Flue Gas Desulfurization System Components for Protective Lining Application
Published Code	ASTM
Publication Date	2003
Pages Count	5
ICS Codes	13.040.40 - Stationary source emissions