ASTM-D5800 2010

$44.96

D5800-10 Standard Test Method for Evaporation Loss of Lubricating Oils by the Noack Method

Published By	Publication Date	Number of Pages
ASTM	2010	18

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method covers three procedures for determining the evaporation loss of lubricating oils (particularly engine oils). Procedure A uses the Noack evaporative tester equipment; Procedure B uses the automated non-Woods metal Noack evaporative apparatus; and Procedure C uses Selby-Noack volatility test equipment. The test method relates to one set of operating conditions but may be readily adapted to other conditions when required.

1.2 Noack results determined using Procedures A and B show consistent differences. Procedure A gives slightly lower results versus Procedure B on formulated engine oils, while Procedure A gives higher results versus Procedure B on basestocks.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method Significance and Use
2	Apparatus Reagents and Materials Hazards
3	FIG. 1
4	Preparation of Apparatus Verification FIG. 2 FIG. 3
5	Procedure Calculations and Results Report Precision and Bias FIG. 4
6	Introduction Apparatus FIG. 5
7	Reagents and Materials Hazards Preparation of Apparatus Verification FIG. 6
8	Procedure FIG. 7
9	Calculation FIG. 8 FIG. 9 FIG. 9
10	Report Precision and Bias FIG. 9 FIG. 10
11	Apparatus Reagents and Materials FIG. 11 FIG. 12
12	Preparation of Apparatus Calibration FIG. 13
14	Sample Procedure Cleaning Calculation Report Precision
15	Quality Control for Procedures A, B, and C Keywords X1. HELPFUL HINTS FOR NOACK VOLATILITY (PROCEDURES A and B) X1.1 X1.2 X1.3 X1.4 X1.5 X1.6 X1.7 X1.8 X1.9 X1.10 X1.11 X1.12 X1.13 X1.14
16	X1.15 X1.16 X1.17 X1.18 X1.19 X1.20 Timing X1.21 X1.22 X1.23 End of Test X1.24 X1.25 X1.26 X2. HELPFUL HINTS FOR SELBY-NOACK VOLATILITY (PROCEDURE C) X2.1 X2.2 X2.3 X2.4 X2.5 X2.6 X3. DRAFT-DEFLECTOR FOR NOACK INSTRUMENTS USED IN PROCEDURES A AND B X3.1 X3.2 X3.3
17	FIG. X3.1

Additional information

Standard Title	D5800-10 Standard Test Method for Evaporation Loss of Lubricating Oils by the Noack Method
Published Code	ASTM
Publication Date	2010
Pages Count	18

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D5800 2010

PDF Catalog

Related products