ASTM-D5948 2005

$44.96

D5948-05 Standard Specification for Molding Compounds, Thermosetting

Published By	Publication Date	Number of Pages
ASTM	2005	18

Guaranteed Safe Checkout

Categories: 83.040.01 - Raw materials for rubber and plastics in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.

1.2 ClassificationMolding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see and ). Note 1There is no equivalent ISO standard.

1.3 Order of PrecedenceIn the event of a conflict between the text of this specification and the references cited in Section (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

1.4 The values stated in SI units are to be considered standard.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents
2	Terminology Significance and Use Requirements Conditioning TABLE 1
3	Test Procedure TABLE 2 TABLE 3
4	TABLE 4 FIG. 1
5	TABLE 5 FIG. 2
6	Quality Assurance Provisions FIG. 3
7	Keywords A1. MOLDING COMPOUNDS, PHENOLIC, THERMOSETTING, CONTAINING CELLULOSE FILLERS A1.1 A1.2 Requirements FIG. 4
8	A2. MOLDING COMPOUNDS, PHENOLIC, THERMOSETTING, CONTAINING MINERAL/GLASS FILLERS A2.1 A2.2 Requirements TABLE A1.1 TABLE A1.2
9	TABLE A2.1 TABLE A2.2
10	A3. MOLDING COMPOUNDS, MELAMINE, THERMOSETTING, CONTAINING CELLULOSE, MINERAL, OR GLASS FILLERS A3.1 A3.2 Requirements TABLE A3.1
11	A4. MOLDING COMPOUNDS, POLYESTER, THERMOSETTING, CONTAINING MINERAL/GLASS FILLERS A4.1 A4.2 Requirements TABLE A3.2 TABLE A4.1
12	A5. MOLDING COMPOUNDS, DIALLYL ISO-PHTHALATE THERMOSETTING, CONTAINING MINERAL FILLERS, GLASS, OR POLYMERIC FILLERS A5.1 A5.2 Requirements A5.3 TABLE A4.2
13	TABLE A5.1 TABLE A5.2
14	A6. MOLDING COMPOUNDS, DIALLYL ORTHO-PHTHALATE THERMOSETTING, CONTAINING MINERAL FILLERS, GLASS, OR POLYMERIC FILLERS A6.1 A6.2 Requirements TABLE A6.1
15	A6.3 Substitutability A7. MOLDING COMPOUNDS, SILICONE, THERMOSETTING, CONTAINING MINERAL/GLASS FILLERS A7.1 A7.2 Requirements TABLE A6.2
16	TABLE A7.1 TABLE A7.2
17	A8. MOLDING COMPOUNDS, EPOXY THERMOSETTING, CONTAINING MINERAL/GLASS FILLERS A8.1 A8.2 Requirements TABLE A8.1
18	TABLE A8.2

Additional information

Standard Title	D5948-05 Standard Specification for Molding Compounds, Thermosetting
Published Code	ASTM
Publication Date	2005
Pages Count	18
ICS Codes	83.040.01 - Raw materials for rubber and plastics in general

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D5948 2005

PDF Catalog

Related products