ASTM-D7053 2007

$40.63

D7053-07 Standard Guide for Determining and Evaluating Causes of Water Leakage of Low-Sloped Roofs

Published By	Publication Date	Number of Pages
ASTM	2007	8

Guaranteed Safe Checkout

Categories: 91.060.20 - Roofs, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D7053-07

Historical Standard: Standard Guide for Determining and Evaluating Causes of Water Leakage of Low-Sloped Roofs

ASTM D7053

Scope

1.1 This guide describes methods for determining and evaluating causes of water leakage in low-sloped roofs. For this purpose, water penetration is considered leakage and therefore problematic, is causing or is likely to cause premature deterioration of the roof, building or its contents, or is adversely affecting the performance of other components of the building A roof is considered an assembly including the membrane, insulation, vapor retarder (if required), deck, and structural components.

1.1.1 This guide excludes moisture-related problems in roofs caused by condensation.

Note 1

Condensation-Moisture-related problems in roof systems may be caused by condensation of humid air originating from within the building and be incorrectly attributed to leakage from rain water. The protocol for an investigation of dampness due to condensation and is complicated, requires special expertise, and is beyond the scope of this guide. For information regarding condensation problems as they relate to roofs, refer to ASTM MNL 18, ASTM MNL 40, and ASHRAE Handbook 2005 Fundamentals.

1.2 Investigative techniques discussed may be intrusive, disruptive, or destructive. It is the responsibility of the investigator to establish the limitations of use, to anticipate and advise of the destructive nature of some procedures, and to plan for repairing and selective reconstruction as necessary.

1.3 This guide does not address steep-sloped roofs, standing or flat seam metal roofs, or architectural standing seam metal roofs.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

Keywords

evaluation; inspection; leaks; low-sloped roof; roof; testing; water leakage

ICS Code

ICS Number Code 91.060.20 (Roofs)

DOI: 10.1520/D7053-07

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Significance and Use
2	Overview Review of Project Documents
3	Evaluation of Design Concept Determination of Service History
4	Inspection
6	Investigative Testing to Reproduce the Leak
7	Analysis Report
8	Keywords

Additional information

Standard Title	D7053-07 Standard Guide for Determining and Evaluating Causes of Water Leakage of Low-Sloped Roofs
Published Code	ASTM
Publication Date	2007
Pages Count	8
ICS Codes	91.060.20 - Roofs