ASTM-D7485 2009

$40.63

D7485-09 Standard Test Method for Determination of Nonylphenol, p-tert-Octylphenol, Nonylphenol Monoethoxylate and Nonylphenol Diethoxylate in Environmental Waters by Liquid Chromatography/Tandem Mass Spectrometry

Published By	Publication Date	Number of Pages
ASTM	2009	10

Guaranteed Safe Checkout

Categories: 13.060.50 - Examination of water for chemical substances, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method covers the determination of nonylphenol (NP), nonylphenol ethoxylate (NP1EO), nonylphenol diethoxylate (NP2EO), and octylphenol (OP), extracted from water utilizing solid phase extraction (SPE), separated using liquid chromatography (LC) and detected with tandem mass spectrometry (MS/MS). These compounds are qualitatively and quantitatively determined by this method. This method adheres to single reaction monitoring (SRM) mass spectrometry.

1.2 The method detection limit (MDL) and reporting limit (RL) for NP, NP1EO, NP2EO, and OP are listed in Table 1.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

TABLE 1 MDL and Reporting Limits

^A MDL Determined Following The Code of Federal Regulations, 40 CFR Part 136, Appendix B.

^B Lowest Point of the Reporting Range is Calculated from the LV 1 Concentration Calibration Standard in Table 4.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology TABLE 1
2	Summary of Test Method Significance and Use Interferences Apparatus Reagents and Materials
3	Hazards Sample Collection, Preservation, and Storage Preparation of LC/MS/MS TABLE 2
4	Calibration and Standardization TABLE 3 FIG. 1 TABLE 4
5	TABLE 5
6	Sample Collection and Solid Phase Extraction Procedure
7	Calculation or Interpretation of Results Report Single Laboratory Precision and Bias TABLE 6
8	TABLE 7 TABLE 8 TABLE 9
9	Keywords TABLE 10 TABLE 11