šŸ”„šŸ”„ Donā€™t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

šŸ”
ASTM-E1448:2009 Edition

ASTM-E1448:2009 Edition

$40.63

E1448/E1448M-09 Standard Practice for Calibration of Systems Used for Measuring Vehicular Response to Pavement Roughness

Published By Publication Date Number of Pages
ASTM 2009 9
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

1.1 This practice describes equipment and procedures for the calibration of systems used for measuring vehicular response to pavement roughness. Such systems are referred to as response-type systems. (See Test Method E1082 .)

1.2 The response-type system includes the driven vehicle, the driver and contents of the vehicle, the towed trailer (if one is used with the system), and a device called a road meter that measures the vehicle response to pavement roughness. The road meter may be mounted in an automobile, van, or in a towed trailer. Response-type (road meter) devices covered in this practice include: devices measuring the relative axle-body motion of a vehicle, devices measuring the vertical acceleration of the vehicle body, and devices measuring the vertical acceleration of the vehicle axle.

1.3 The calibration procedures described in this practice are limited to the use of the simulations described in Practice E1170 .

1.4 This practice is not intended to apply to pavement roughness measuring equipment whose output is not influenced by the response of the host vehicle.

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
2 Significance and Use
Apparatus
3 Selecting Calibration Sites
Determining the Standard Roughness Index for Calibration Sites
4 Determining the Response-Type System Numbers (RTSNs) for Calibration Sites
Regression Analysis and Error Estimation
Response-Type System Calibration Verification
Report
5 Keywords
X1. RESPONSE-TYPE SYSTEM CALIBRATIONā€”LEAST SQUARES REGRESSION AND ERROR ESTIMATION
X1.1
X1.2
X1.3
X1.4
6 X2. SELECTION OF CALIBRATION SITES
X2.1
X2.2
FIG. X1.1
TABLE X1.1
7 X2.3
X3. RESPONSE-TYPE SYSTEM CALIBRATIONā€”EQUATION VERIFICATION PROCEDURE
X3.1
X3.2
X3.3
X3.4
TABLE X3.1
8 FIG. X3.1
9 FIG. X3.2
TABLE X3.2
TABLE X3.3

Related products

ASTM-E1448
$40.63