šŸ”„šŸ”„ Donā€™t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

šŸ”
ASTM-F1667:2015 Edition

ASTM-F1667:2015 Edition

$63.38

F1667-15 Standard Specification for Driven Fasteners: Nails, Spikes, and Staples

Published By Publication Date Number of Pages
ASTM 2015 47
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

ASTM F1667-15

Historical Standard: Standard Specification for Driven Fasteners: Nails, Spikes, and Staples

ASTM F1667

Scope

1.1 This specification covers nails, spikes, staples, and other driven fasteners, as listed in Table 1.

Note 1: Fastener ductility information is presented in Table 2 and dimensional information in Tables 3ā€“65.

(A) All dimensions given in inches.

(A) All dimensions are given in inches.

(A) All dimension are given in inches.

(A) All dimensions are given in inches.

(A) All dimensions are given in inches.
(B) Dashes (ā€”) indicate that the fastener size is not a standard size.

ā€ ā€‰Editorially corrected in March 2012.

(A) All dimensions are given in inches.
(B) Dashes (ā€”) indicate that the fastener size is not a standard size.

(A) All dimensions are given in inches.
(B) Root diameter is a calculated value and is not specified as a dimension to be measured.

(A) All dimensions are given in inches.
(B) Nails shall comply with the supplementary requirements of S1 and Table S1.1.
(C) Nails identified as ā€œF1667 NLRSRSā€ must meet all applicable requirements of F1667 for the specified roof sheathing ring shank nail.
(D) Individual rings shall be approximately frustrums, circular in transverse cross section, axially symmetric, and formed on the nail axis such that the minor diameter is closer to the nail point and the major diameter is closer to the nail head. The thread shall be continuous over the minimum thread length, TLmin.

(A) All dimensions are given in inches.

(A) All dimensions are given in inches.

1.2 Fasteners described in this specification are driven by hand tool, power tool, or mechanical device in single or multiple strikes and are positioned by hand, tool, or machine.

1.3 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 Fasteners in this specification are sold in bulk (loose) form and are collated for loading into the magazine of an application tool. Other than as covered in Section 9, Workmanship, cohering materials (including, but not limited to, plastic, adhesive bond, paper tape, plastic strip, plastic carrier, wire, etc.) and relative orientation of collated fasteners are not within the scope of this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

diameter; driven fasteners; head; length; nails; point; spikes; staples;

ICS Code

ICS Number Code 21.060.01 (Fasteners in general)

DOI: 10.1520/F1667-15

Related products

ASTM-F1667
$63.38