ASTM-F2735 2008

$40.63

F2735-08 Standard Specification for Plastic Insert Fittings For SDR9 Cross-linked Polyethylene (PEX) and Polyethylene of Raised Temperature (PE-RT) Tubing

Published By	Publication Date	Number of Pages
ASTM	2008	5

Guaranteed Safe Checkout

Categories: 23.040.45 - Plastics fittings, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F2735-08

Historical Standard: Standard Specification for Plastic Insert Fittings For SDR9 Cross-linked Polyethylene (PEX) and Polyethylene of Raised Temperature (PE-RT) Tubing

ASTM F2735

Scope

1.1 This specification establishes requirements for sulfone plastic insert fittings and copper crimp rings for three sizes ( ½, ¾, and 1) of cross-linked polyethylene (PEX) and polyethylene of raised temperature (PE-RT) plastic tubing. These fittings are intended for use in 100 psi (690 kPa) cold- and hot-water distribution systems operating at temperatures up to and including 180°F (82°C). Included are the requirements for material, molded part properties, performance, workmanship, dimensions, and markings to be used on the fittings and rings.

1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The following is an index of the appendix in this specification.

1.4 The following precautionary caveat pertains only to the test method portions, Sections 11 and 12, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

cold- and hot-water distribution; copper crimp rings; cross-linked polyethylene; plastic insert fittings; PEX; PE-RT

ICS Code

ICS Number Code 23.040.45 (Plastic fittings)

DOI: 10.1520/F2735-08

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Classification Ordering Information
2	Molded Part Properties Performance Requirements FIG. 1
3	Dimensions Workmanship, Finish and Appearance Assembly Test Methods Molded Part Properties Test Methods Restest Quality Assurance FIG. 2 TABLE 1
4	Product Marking Keywords X1. GO/NO-GO CRIMP GAUGE X1.1 X1.2 X1.3 FIG. 3 FIG. 4
5	FIG. X1.1