ASTM-F3633 2023

$29.79

F3633-23 Standard Guide for Measuring the Adhesion of Crude Oils and Fuel Oils

Published By	Publication Date	Number of Pages
ASTM	2023

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F3633-23

Active Standard: Standard Guide for Measuring the Adhesion of Crude Oils and Fuel Oils

ASTM F3633

Scope

1.1 This guide summarizes a method to measure the adhesion to a stainless-steel needle as means to compare the relative adhesion of the target oil.

1.2 This guide covers general procedures for measuring the adhesion of oils to stainless steel and does not cover all possible procedures that may be applicable to this topic.

1.3 The accuracy of this guide depends very much on the representative nature of the oil sample used. Certain oils can have different properties depending on their chemical contents at the time a sample is taken.

1.4 Units—The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

oil adhesion; oil adhesion to stainless steel ;

ICS Code

ICS Number Code 75.040 (Crude petroleum)

DOI: 10.1520/F3633-23

Additional information