ASTM-F690 2003

$40.63

F690-86(2003)e2 Standard Practice for Underground Installation of Thermoplastic Pressure Piping Irrigation Systems

Published By	Publication Date	Number of Pages
ASTM	2003	6

Guaranteed Safe Checkout

Categories: 23.040.20 - Plastics pipes, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM F690-86-e2-Reapproved2003

Withdrawn Standard: Standard Practice for Underground Installation of Thermoplastic Pressure Piping Irrigation Systems (Withdrawn 2012)

ASTM F690

Scope

1.1 This practice covers general and basic procedures related to the proper installation of thermoplastic, flexible, pressure piping, 36 in. nominal size and smaller, for underground irrigation systems. Because there is considerable variability in end-use requirements, soil conditions, and thermoplastic piping characteristics, it is the intent of this practice to outline general objectives and basics of proper installation and to provide pertinent references, rather than to prescribe detailed installation procedures.

1.2 This practice should not be used for installing thermoplastic underground sewer, drain, potable water, conduit or gas service piping.

1.3 The values stated in inch-pound units are to be regarded as the standard. Values in parentheses are given for information only.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

drainage systems-land drainage; underground installation of thermoplastic pressure piping irrigation; systems, practice; installation-underground; thermoplastic pressure piping irrigation systems, practice

ICS Code

ICS Number Code 23.040.20 (Plastic pipes)

DOI: 10.1520/F0690-86R03E02

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Joints and Connections Trench Preparation
2	Pipe Assembly and Installation
3	Thrust Blocking Line Charging and Testing FIG. 1
4	Backfilling Procedures FIG. 2
5	Keywords X1. RELATED DOCUMENTS X1.1 The following ASTM documents contain information related to this practice:

Additional information

Standard Title	F690-86(2003)e2 Standard Practice for Underground Installation of Thermoplastic Pressure Piping Irrigation Systems
Published Code	ASTM
Publication Date	2003
Pages Count	6
ICS Codes	23.040.20 - Plastics pipes