AWWA C507 2011

$75.83

AWWA C507-11: Ball Valves, 6 Inch Thru 48 Inch (150 MM Thru 1,200 MM)

Published By	Publication Date	Number of Pages
AWWA	2011	40

Guaranteed Safe Checkout

Category: AWWA

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

This standard covers gray-iron, ductile-iron, and cast-steel, flanged-end, tight-shutoff, shaft- or trunnion-mounted, full-port, double- and single-seated ball valves for pressures up to 300 psi (2,100 kPa) in sizes from 6-in. through 48-in. (150-mm throu

PDF Catalog

PDF Pages	PDF Title
1	ANSI/AWWA C507-11
3	Committee Personnel
5	Contents
7	Foreword I. Introduction.
8	II. Special Issues.
10	III. Use of This Standard.
12	IV. Major Revisions. V. Comments.
13	AWWA Standard Ball Valves, 6 In. Through 60 In. (150 mm Through 1,500 mm) SECTION 1: GENERAL Sec. 1.1 Scope
14	Sec. 1.2 Purpose Sec. 1.3 Application Sec. 1.4 Valve Construction Sec. 1.5 Description of Operation SECTION 2: REFERENCES
16	SECTION 3: DEFINITIONS
18	SECTION 4: REQUIREMENTS Sec. 4.1 Data to Be Provided by the Manufacturer or Supplier Sec. 4.2 Materials
19	Sec. 4.3 Design
20	Table 1 Port diameter and minimum body shell thickness
26	Table 2 Safety factors for cylinder actuator torque output
27	Sec. 4.4 Workmanship and Coatings
28	SECTION 5: VERIFICATION Sec. 5.1 Production Testing
29	Sec. 5.2 Proof-of-Design Tests
30	SECTION 6: DELIVERY Sec. 6.1 Marking Sec. 6.2 Preparation for Shipment
31	Sec. 6.3 Handling, Storage, and Installation Sec. 6.4 Notice of Nonconformance Sec. 6.5 Affidavit of Compliance
33	APPENDIX A Installation, Operation, and Maintenance of Ball Valves SECTION A.1: GENERAL SECTION A.2: UNLOADING SECTION A.3: STORAGE
34	SECTION A.4: INSPECTION PRIOR TO INSTALLATION SECTION A.5: INSTALLATION
35	SECTION A.6: FIELD TESTING
36	SECTION A.7: OPERATION SECTION A.8: MAINTENANCE