BS EN 124-2:2015

This European Standard is applicable to gully tops and manhole tops made of flake graphite cast iron and/or spheroidal graphite cast iron whether in combination with concrete or not, with a clear opening up to and including 1 000 mm for covering gullies, manholes and inspection chambers for installation within areas subjected to pedestrian and/or vehicular traffic.

It is applicable to manhole tops and gully tops for use in

• areas which can only be used by pedestrians and pedal cyclists (at least class A 15),

• pedestrian areas and comparable areas, car parks or car parking decks (at least class B 125),

• the area of kerbside channels of roads which, when measured from the kerb edge, extends a maximum of 0,5 m into the carriageway and a maximum of 0,2 m into the pedestrian area (at least class C 250),

• carriageways of roads (including pedestrian streets), hard shoulders and parking areas, for all types of road vehicles (at least class D 400),

• areas imposing high wheel loads, e.g. docks, aircraft pavements (at least class E 600),

• areas imposing particularly high wheel loads, e.g. aircraft pavements (class F 900).

This European Standard is not applicable in isolation but only in combination with EN 124‑1 and gives guidance for combinations of covers/grating made of cast iron with frames according to EN 124‑3 , EN 124‑4 , EN 124‑5 or EN 124‑6 .

This European Standard is not applicable to:

• cover fillings installed on site, e.g. concrete, paving blocks, etc.;

• concave gratings for class D 400 installed in carriageways of roads or hard shoulders and concave gratings for classes F 900 and E 600;

• gratings/covers as part of prefabricated drainage channels according to EN 1433 ;

• floor and roof gullies in buildings which are specified in EN 1253 (all parts); and

• surface boxes.