BS EN 60317-0-4:2016
$142.49
Specifications for particular types of winding wires – General requirements. Glass-fibre wound, resin or varnish impregnated, bare or enameled rectangular copper wire
| Published By | Publication Date | Number of Pages |
| BSI | 2016 | 30 |
This part of IEC 60317 specifies general requirements of glass-fibre wound, resin or varnish impregnated, bare or enamelled rectangular copper wire.
The range of nominal conductor dimensions is given in the relevant specification sheet.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 4 | European foreword Endorsement notice |
| 5 | Annex ZA (normative) Normative references to international publications with their corresponding European publications |
| 6 | English CONTENTS |
| 8 | FOREWORD |
| 10 | INTRODUCTION |
| 11 | 1 Scope 2 Normative references 3 Terms, definitions and general notes on tests and appearance 3.1 Terms and definitions |
| 12 | 3.2 General notes 3.2.1 Methods of test 3.2.2 Winding wire |
| 13 | 3.3 Appearance 4 Dimensions 4.1 Conductor dimensions |
| 14 | Tables Table 1 – Nominal cross-sectional areas of preferred sizes |
| 15 | 4.2 Tolerance on conductor dimensions 4.3 Rounding of corners 4.4 Increase in dimensions due to the insulation Table 2 – Conductor tolerances Table 3 – Corner radii |
| 16 | Table 4 – Increase in dimensions |
| 17 | 4.5 Overall dimensions 4.5.1 Nominal overall dimensions 4.5.2 Minimum overall dimensions 4.5.3 Maximum overall dimensions 5 Electrical resistance 6 Elongation 7 Springiness Table 5 – Elongation |
| 18 | 8 Flexibility and adherence 8.1 Mandrel winding test 8.2 Adherence test 8.2.1 Glass-fibre covered bare wires 8.2.2 Glass-fibre covered enamelled wires 9 Heat shock 10 Cut-through 11 Resistance to abrasion 12 Resistance to solvents 13 Breakdown voltage Table 6 – Mandrel winding |
| 19 | 14 Continuity of insulation 15 Temperature index 16 Resistance to refrigerants 17 Solderability 18 Heat or solvent bonding 19 Dielectric dissipation factor 20 Resistance to transformer oil 21 Loss of mass Table 7 – Breakdown voltage |
| 20 | 23 Pin hole test 30 Packaging |
| 21 | Annex A (informative) Nominal cross-sectional areas for preferred and intermediate sizes Table A.1 – Nominal cross-sectional areas (1 of 7) |
| 28 | Bibliography |
