BS EN 60317-0-7:2012
$142.49
Specifications for particular types of winding wires – General requirements. Fully insulated (FIW) zero-defect enamelled round copper wire with nominal conductor diameter of 0,040 mm to 1,600 mm
| Published By | Publication Date | Number of Pages |
| BSI | 2012 | 24 |
This part of IEC 60317 establishes general requirements for fully insulated (FIW) zero-defect enamelled round copper wires.
The nominal conductor diameter range is given in the relevant technical specification.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | English CONTENTS |
| 8 | INTRODUCTION |
| 9 | 1 Scope 2 Normative references 3 Terms, definitions, general notes and appearance 3.1 Terms and definitions |
| 11 | 3.2 General notes 3.2.1 Methods of test 3.2.2 Winding wire 3.3 Appearance 4 Dimensions 4.1 Conductor diameter |
| 12 | 4.2 Out of roundness of conductor (for nominal diameters over 0,063 mm) 4.3 Minimum overall diameter 4.4 Maximum overall diameter |
| 13 | Tables Table 1 – Dimensions of enamelled wires (R 20) (1 of 2) |
| 15 | 5 Electrical resistance 6 Elongation Table 2 – Electrical resistance Table 3 – Elongation at break |
| 16 | 7 Springiness 8 Flexibility and adherence 8.1 Mandrel winding test (for nominal conductor diameters up to and including 1,600 mm) Table 4 – Springiness |
| 17 | 8.2 Jerk test (for nominal diameters up to and including 1,000 mm) 9 Heat shock Table 5 – Mandrel diameters for mandrel winding test |
| 18 | 10 Cut Through 11 Resistance to abrasion 12 Resistance to solvents Table 6 – Heat shock |
| 19 | 13 Breakdown voltage 14 Continuity of insulation (nominal conductor diameters up to and including 1,600 mm) 14.1 Off-line high voltage continuity 14.2 In-line high voltage continuity 15 Temperature index 16 Resistance to refrigerants Table 7 – Breakdown voltage |
| 20 | 17 Solderability 18 Heat or solvent bonding 19 Dielectric dissipation factor 20 Resistance to transformer oil 21 Loss of mass 23 Pin-hole test 30 Packaging |
| 21 | Annex A (informative) Dimensions for intermediate nominal conductor diameter values (R 40) Table A.1 – Dimensions of enamelled wires without a bonding layer (R 40) |
