BS EN 61300-3-51:2014
$102.76
Fibre optic interconnecting devices and passive components. Basic test and measurement procedures – Examinations and measurements. Pin gauge withdrawal force for rectangular ferrule multi-fibre connectors
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 22 |
IEC 61300-3-51:2014 is intended to describe the procedure required to measure the pin gauge withdrawal force for rectangular ferrule multi-fibre connectors. This measurement can be used as an alternative to the measurement of the pin gauge insertion force, both of which evaluate the fit of the pin gauge(s) into the guide pin hole(s) of the female-type connector. The experimental verification of interchangeability between them is shown in Annex A. For the male-type connector, IEC 61300-3-49 is applied to evaluate how securely the guide pins are retained in the guide holes. Keywords: pin gauge withdrawal force, pin gauge insertion force
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | English CONTENTS |
| 8 | 1 Scope 2 Normative references |
| 9 | 3 General description 3.1 General 3.2 Test conditions 4 Apparatus 4.1 Fixture 4.2 Pin gauge chuck 4.3 Plug gauge chuck 4.4 Pin gauge Tables Table 1 – Test conditions |
| 10 | 4.5 Plug gauge Figures Figure 1 – Pin gauge Figure 2 – Plug gauge for guide pin holes Table 2 – Dimensions of the pin gauge |
| 11 | 4.6 Weight 4.7 Tensile testing machine 5 Procedure 5.1 Method A: Method using the weight (Figure 3) Table 3 – Dimensions for plug gauge for guide pin holes |
| 12 | 5.2 Method B: Method using the tensile testing machine (Figure 4) Figure 3 – Method A for examination of pin gauge/plug gauge withdrawal force (method using the weight) |
| 13 | Figure 4 – Method B for examination of pin gauge/plug gauge withdrawal force (method using the tensile testing machine) |
| 14 | 6 Details to be specified |
| 15 | Annex A (informative) Experimental verification of the interchangeability between the pin gauge insertion force and the pin gauge withdrawal force A.1 General A.2 Measurement system A.3 Measurement sample Figure A.1 – Measurement system |
| 16 | A.4 Measurement procedure A.5 Measurement results Figure A.2 – Insertion/withdrawal force measurement results Table A.1 – Guide hole pitch of measurement samples |
| 17 | A.6 Conclusion |
| 18 | Annex B (informative) Experimental verification of compatibility of Method A (method using the weight) and Method B (method using the tensile testing machine) Figure B.1 – Relation between the withdrawal force values measured by Method A and Method B |
| 19 | Bibliography |
