BS EN ISO 6272-1:2004
$102.76
Paints and varnishes. Rapid-deformation (impact resistance) tests – Falling-weight test, large-area indenter
| Published By | Publication Date | Number of Pages |
| BSI | 2004 | 18 |
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 5 | TitlePage – Paints and varnishes�— Rapid-deformation (impact resistance) tests�— |
| 7 | TableofContent – Contents Page |
| 8 | Foreword – Foreword |
| 9 | Scope – 1��� Scope NormativeReference – 2��� Normative references |
| 10 | Clause1 – 3��� Required supplementary information Clause1 – 4��� Apparatus UntitledSubclause2 – 4.1��� Falling-weight apparatus UntitledSubclause3 – 4.1.1��� Base stand UntitledSubclause3 – 4.1.2��� Primary falling weight UntitledSubclause3 – 4.1.3��� Secondary weight(s) UntitledSubclause3 – 4.1.4��� Vertical guide tube UntitledSubclause3 – 4.1.5��� Die UntitledSubclause3 – 4.1.6��� Clamping sleeve UntitledSubclause3 – 4.1.7��� Stops UntitledSubclause2 – 4.2��� Viewing lens Clause1 – 5��� Sampling |
| 12 | Clause1 – 6��� Test panels Subclause2 – 6.1��� Substrate |
| 13 | Subclause2 – 6.2��� Preparation and coating Subclause2 – 6.3��� Drying Subclause2 – 6.4��� Thickness of coating Clause1 – 7��� Procedure Subclause2 – 7.1��� General Subclause2 – 7.2��� Pass/fail test (using a specified mass) Subclause2 – 7.3��� Classification test (to determine the minimum drop height and mass which will… UntitledSubclause3 – 7.3.1��� Ensure that the guide tube ( |
| 14 | UntitledSubclause3 – 7.3.2��� Remove the test panel from the apparatus and examine the deformed a… UntitledSubclause3 – 7.3.3��� Once cracks and/or peeling are observed, carry out the following pr… UntitledSubclause3 – 7.3.4��� Examine the relevant areas of the coating with the lens ( UntitledSubclause3 – 7.3.5��� If no end point can be established, repeat the procedure of Clause1 – 8��� Precision Clause1 – 9��� Test report |
| 15 | AnnexNormative – Required supplementary information |
