BS ISO 13041-5:2015
$167.15
Test conditions for numerically controlled turning machines and turning centres – Accuracy of speeds and interpolations
| Published By | Publication Date | Number of Pages |
| BSI | 2015 | 44 |
This part of ISO 13041 specifies, with references to ISO 230-1 and ISO 230-4, certain kinematic tests for numerically controlled (NC) turning machines and turning centres, concerning the spindle speeds, the feed speeds of the individual NC linear axes, and the accuracy of the paths described by the simultaneous movement of two or more NC linear and/or rotary axes.
NOTE This part of ISO 13041 applies to numerically-controlled turning machines and turning centres with horizontal, vertical, and inverted vertical type workholding spindle(s).
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Introduction |
| 9 | 1 Scope 2 Normative references 3 Terms and definitions |
| 11 | 4 Preliminary remarks 4.1 Measurement units 4.2 Reference to ISO 230-1 and ISO 230-4 |
| 12 | 4.3 Testing sequence 4.4 Tests to be performed 4.5 Measuring instruments 4.6 Software compensation 5 Tests described in Annexes A to C |
| 13 | Annex A (normative) Kinematic tests for machines with a horizontal workholding spindle |
| 21 | Annex B (normative) Kinematic tests for machines with a vertical workholding spindle |
| 29 | Annex C (normative) Kinematic tests for machines with inverted vertical workholding spindles |
| 37 | Annex D (informative) Precautions for test setup for AK6, BK6, and CK6 |
| 41 | Bibliography |
