Shopping Cart

No products in the cart.

IEEE 1591.3 2011

$37.38

IEEE Standard for Qualifying Hardware for Helically-Applied Fiber Optic Cable Systems (WRAP Cable)

Published By Publication Date Number of Pages
IEEE 2011 29
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

New IEEE Standard – Active. The purpose of this standard is to establish performance and testing specifications for hardware used on WRAP CABLE systems in order to standardize testing, simplify procurement specifications, and assure product quality.

PDF Catalog

PDF Pages PDF Title
1 IEEE Std 1591.3™-2011 Front cover
3 Title page
6 Introduction
Notice to users
Laws and regulations
Copyrights
Updating of IEEE documents
7 Errata
8 Participants
10 Contents
11 IMPORTANT NOTICE
1. Overview
1.1 Scope
1.2 Purpose
12 2. Normative references
3. Definitions and acronyms
3.1 Definitions
3.2 Acronyms
13 4. Requirements for WRAP cable hardware
4.1 General requirements
4.1.1 Tower bypass fittings
4.1.2 Span end clamps
14 4.1.3 Conductor mounted splice enclosure
4.1.4 Tower-mounted splice enclosure
15 4.1.5 Ground wire down leg transition
4.1.6 Phase conductor phase-to-ground transition
16 4.2 Material requirements
4.2.1 Design selection
4.2.2 Finish/workmanship
4.2.3 Thermal design requirements
17 5. Design and installation considerations for the hardware
5.1 Surface leakage currents
5.2 Radio interference voltage (RIV) and corona
6. Qualification testing
6.1 Optical measurements
18 6.1.1 Fibers to be measured
19 6.2 Retesting
6.3 Sample selection for hardware characteristics tests
6.4 Qualification tests
6.4.1 Bypass fitting
20 6.4.2 Span end clamp
6.4.3 Pipe tower clamp
21 6.4.4 Tower splice enclosure
22 6.4.5 Phase-to-ground insulator
25 Annex A (informative) System overview
28 Annex B (informative) Glossary
IEEE 1591.3 2011
$37.38