Shopping Cart

No products in the cart.

IEEE 2715-2023

$39.54

IEEE Guide for the Characterization of the Shielding Effectiveness of Planar Materials (Approved Draft)

Published By Publication Date Number of Pages
IEEE 2023
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

New IEEE Standard – Active. A set of standard methods and procedures for determining the shielding effectiveness of planar materials is provided. Such materials might comprise, but are not limited to, metals, coated plastics, fiber-filled polymers, textiles, and coated fabrics. The selection of the appropriate test method to determine the level of shielding provided in the intended application, to provide a basis for comparing the measuring results, is considered. Emphasis is placed on those measurement techniques that have been adopted through incorporation into standards, both commercial and military, or that have been used extensively in practice.

PDF Catalog

PDF Pages PDF Title
1 IEEE Std 2715™-2023 Front cover
2 Title page
4 Important Notices and Disclaimers Concerning IEEE Standards Documents
8 Participants
9 Introduction
10 Contents
11 1. Overview
1.1 Scope
1.2 Background
12 1.3 Word usage
2. Normative references
3. Definitions, acronyms, and abbreviations
3.1 Definitions
13 3.2 Acronyms and abbreviations
14 4. Factors affecting the shielding effectiveness (SE) of planar materials
17 5. Standardized SE measurement techniques
ASTM D4935–18
20 6. SE measurement techniques derived from standardized techniques
6.1 ASTM D4935–18—high-frequency variants
21 6.2 IEEE Std 299-2006 (based on the obsolete MIL-STD-285 [B22])
23 6.3 Reverberation chambers (RCs)
28 7. Non-standardized SE measurement techniques
7.1 General
7.2 Far field TEM-t fixture
30 7.3 Near field (NF) H-t fixture
31 7.4 Dual TEM
32 7.5 Waveguide
33 7.6 “Quasi-optical” bench
35 7.7 Absorber box
37 8. Selecting an SE measurement technique
8.1 General
8.2 Material type
38 8.3 Sample fabrication and reference samples
8.4 Sample configuration
8.5 Frequency range
39 8.6 Dynamic range (DR)
8.7 Other considerations
9. Repeatability and measurement uncertainty
9.1 Repeatability
41 9.2 Measurement uncertainty
10. Test plan
10.1 General
10.2 Test plan parameters to be defined
10.3 Calibration
10.4 DR
42 11. Technical report
11.1 General
11.2 Status letter
11.3 Full test report
45 Annex A (informative) Summary of measuring techniques for planar materials
49 Annex B (informative) Shielding theory
53 Annex C (informative) Bibliography
56 Back cover
IEEE 2715-2023
$39.54