This document establishes the rules for verifying the conformity or nonconformity with a given tolerance for a characteristic of a workpiece (or a population of workpieces) or with a given maximum permissible errors for a metrological characteristic of a measuring equipment, including when the measured value falls close to the specification limits, taking measurement uncertainty into account.<\/p>\n
This document applies to specifications defined in general GPS standards (see ISO 14638 ), i.e. standards prepared by ISO\/TC 213, including:<\/p>\n
workpiece specifications and population specifications (usually given as an upper specification limit or a lower specification limit or both);<\/p>\n<\/li>\n
measuring equipment specifications (usually given as maximum permissible errors).<\/p>\n<\/li>\n<\/ul>\n
This document only applies for characteristics and maximum permissible errors expressed as quantity values.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 2<\/td>\n | undefined <\/td>\n<\/tr>\n | ||||||
| 6<\/td>\n | Foreword <\/td>\n<\/tr>\n | ||||||
| 7<\/td>\n | Introduction <\/td>\n<\/tr>\n | ||||||
| 8<\/td>\n | 1 Scope 2 Normative references 3 Terms and definitions <\/td>\n<\/tr>\n | ||||||
| 14<\/td>\n | 4 Default decision rules 4.1 General <\/td>\n<\/tr>\n | ||||||
| 18<\/td>\n | 4.2 Default conformance probability limit 4.3 Default nonconformance probability limit 5 Verifying conformity and nonconformity with specifications 5.1 General <\/td>\n<\/tr>\n | ||||||
| 19<\/td>\n | 5.2 Rule for verifying conformity with specifications 5.2.1 General 5.2.2 Case of normal PDF and default conformance probability limit <\/td>\n<\/tr>\n | ||||||
| 21<\/td>\n | 5.3 Rule for verifying nonconformity with specifications 5.3.1 General 5.3.2 Case of normal PDF and default nonconformance probability limit <\/td>\n<\/tr>\n | ||||||
| 22<\/td>\n | 5.4 Uncertainty zone <\/td>\n<\/tr>\n | ||||||
| 23<\/td>\n | 6 Application in a supplier\/customer relationship 6.1 General 6.2 Supplier verifying conformity <\/td>\n<\/tr>\n | ||||||
| 24<\/td>\n | 6.3 Customer verifying nonconformity <\/td>\n<\/tr>\n | ||||||
| 25<\/td>\n | Annex A (informative) Relation between the third edition and the second edition <\/td>\n<\/tr>\n | ||||||
| 28<\/td>\n | Annex B (informative) Relation to the GPS matrix model <\/td>\n<\/tr>\n | ||||||
| 30<\/td>\n | Bibliography <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" Geometrical product specifications (GPS). Inspection by measurement of workpieces and measuring equipment – Decision rules for verifying conformity or nonconformity with specifications<\/b><\/p>\n |