1.1 This test method covers a rapid portable means for field and laboratory use to rate the ability of aviation turbine fuels to release entrained or emulsified water when passed through fiberglass coalescing material.<\/p>\n
1.2 The procedure section of this test method contains two different modes of test equipment operation. The primary difference between the modes of operation is the rate of fuel flow through the fiberglass coalescing material. Test method selection is dependent on the particular fuel to be tested.<\/p>\n
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.<\/p>\n
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 1<\/td>\n | Scope Referenced Documents Terminology Summary of Test Method <\/td>\n<\/tr>\n | ||||||
| 2<\/td>\n | Significance and Use Apparatus TABLE 1 <\/td>\n<\/tr>\n | ||||||
| 3<\/td>\n | FIG. 1 FIG. 2 TABLE 2 <\/td>\n<\/tr>\n | ||||||
| 4<\/td>\n | Reagents FIG. 3 TABLE 3 TABLE 4 TABLE 5 <\/td>\n<\/tr>\n | ||||||
| 5<\/td>\n | Preparation of Apparatus Sample Preparation Procedure <\/td>\n<\/tr>\n | ||||||
| 6<\/td>\n | FIG. 4 FIG. 5 <\/td>\n<\/tr>\n | ||||||
| 7<\/td>\n | Report Precision and Bias TABLE 6 FIG. 6 FIG. 7 FIG. 8 <\/td>\n<\/tr>\n | ||||||
| 8<\/td>\n | FIG. 9 FIG. 10 <\/td>\n<\/tr>\n | ||||||
| 9<\/td>\n | Keywords X1. PREPARATION OF REFERENCE FLUID BASE X1.1 Scope X1.2 Summary of Procedure X1.3 Apparatus X1.4 Materials X1.5 Preparation of Apparatus <\/td>\n<\/tr>\n | ||||||
| 10<\/td>\n | X1.6 Filtration Procedure X1.7 Clean the Column X1.8 Water Washing the Base Fuel X1.9 Procedure X2. SAMPLING TECHNIQUE X2.1 X2.2 Sample Container <\/td>\n<\/tr>\n | ||||||
| 11<\/td>\n | X3. CORRELATION OF MICRO-SEPAROMETER MSEP-A RATINGS X3.1 Introduction X3.2 Precision of MSEP-A Ratings X3.3 Correlation of MSEP-A and MSS Ratings X3.4 MSEP-A Ratings Level Versus Fuel Type X3.5 Correlation of MSEP-A Ratings with Field Experience <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" D3948-07 Standard Test Method for Determining Water Separation Characteristics of Aviation Turbine Fuels by Portable Separometer<\/b><\/p>\n |